You just have to click Simulation mode as shown.īut, in this software, there is no IP address assigned for simulation mode. You just have to click Simulation as shown.Īfter the program has been downloaded, just put the PLC in run mode and you can check it in simulation.īut, in this software, there is no IP address assigned for simulation mode. After the program has been downloaded, just put the PLC in run mode and you can check it in simulation. After politely introducing himself, the service technician puts on. The lowvoltage power supply is at the air handler. It too takes the IP address of 127.0.0.1. This system has an electric furnace with the air handler (fan section) mounted above the suspended ceiling in the stockroom. You just have to click Launch Simulator as shown below. You cannot put any other address for simulation. Note that the IP address must be 127.0.0.1 for simulation mode. With these steps, you can check the logic in simulation mode. Click OK then you can do the PLC simulation.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |